Bust Through A Wall
Now I begin to be satisfied with the first klip and all there is too it is tweeking.
Not much learning and new things left there.
So I have begin working with the wall vlip some more.
The scene is tracked and works quite well.
And now i’m working with a recreation of that hole test i did earlier.
This clip under shows how I made it.
But I fill with some text too.
Step1: I made the shatters by hand. Then I duplicated and made them smaller.
By that the simulation runs more smoothly.
step2: Then I had an projectile go thrue the wall in qute a slow speed.
And allt the settings at the simulation set to be slower. The I baked the simulation.
Step3: Now i desided how fast and when the animation should go off.
Because of the curvs I could also deside where they should go.
So the baked simulation worked more lika a guide that I could tweek by hand.
Step4: When the shatters behave like I wanted. I started to build all the debris.
All the wall constrution material like, isolation, balks and planks and so on.
Step5: This stuff I shattered and the where easy to animate by hand as I followed the alredy animated stuff.