I’ve created a breakdown of my layers in my short film. I don’t show every single layer because that would take to long, I put some of them together from the start, but I think you will get a pritty good idea of how many they are.
Breakdown.mov (H.264 - 31,7 MB)
Breakdown.mov (Motion JPEG A - 148 MB)
I’ve also changed some of the video links here in the blogg so that this page wont take that long to load.
Enjoy =)
Finally, at the last minute I feel that I can let everything go and say that I’m finished.
I’m probably going to work some more on the details before the last presentation, but here is my MS3 delivery:
Documents:
My Project Plan v1.3.doc
My Project Plan v1.3.pdf
My Research_v1.2.doc (Updated)
My Research_v1.2.pdf (Updated)
My References_v1.1.doc
My References_v1.1.pdf
My PostMortem.doc
My PostMortem.pdf
The short film of the tornado:
VisualEffects_Tornado.mov (H.264 - 54,9 MB)
VisualEffects_Tornado2.mov (Motion JPEG A - 116 MB)
And I close this up with a image of my node system in Fusion:
This last week before MS3 I’m working with compositing. I have rendered out almost every layer that I need from Maya (I still have about two more on the top of my wish list).
I’ve been creating most of the layers in Maya but I’m also working with particles in Fusion. I’ve used Fusion to create the snowparticles that would fall closest to the camera. To optimize the time it takes too uppdate and render in Fusion I have rendered out the snow layers that I created in Fusion into image sets soo that I could add them whit loaders again to my material.
A test on my snow layers closest to the camera.
I’m going too add more snow that brakes up the line between the snow on the ground and the trees closest to the camera and two more layers further away too get more depth in the film.
TornadoTest33_snowlayers.mov (Motion JPEG A)
For the moment I’m working on the tracking and the masks. There is a lot of tweaking left and I still have some snow layers that I would want to add but I’m geting closer to the result I’m after.
This is a test I rendered out last night.
TornadoTest32_layertest.mov (Motion JPEG A)
I’ve updated my Project Plan, I have added my wokflow schedule between MS2 and MS3.
I’ve created a simple visualization of my short film. It’s a bit shaky still, even though I’ve managed to reduse the worst from the filmed material. I have arranged so that I can film some more material whit a higher resolution and a camera stand to reduce the shaking.